![]() ![]() Than the only reason could be that the switching signal is too low or none at all. Since I tried 3 different switches I assume the switch is not at fault. ![]() I have attached some screenshots of the receiver settings (Spaun is a non-committed switch so I configured accordingly.) All with the same result. ![]() Infosat 4x1 model DSS4101, Novakova 2x1 and Spaun SUR 211F. Since the DiSEQc is a normally closed switch over input 1, this input will always work, which is the case. Tuner A configured for C-band (AB), Manual scan: no C-channels Tuner A configured for Ku-band (AA), Manual scan: all Ku channels Tuner A configured for Ku-band on input 2 (AB), Manual scan: no Ku-channelsĭish-C connected to DiSEQc input 2, Dish-Ku connected to input 1. Tuner A configured for C-band on input 1 (AA), Manual scan: receive all C-channels This because I do not configure correctly or the box does not generate a signal indeed?Ĭonfiguration: One dish with Ku-LNB, One dish with C-LNB, One cable running to Receiver box.ĭish- C connected to DiSEQc input 1, Dish- Ku connected to input 2 This because most of the signal is lost over the cable(25/30 meters) or the box does not generate a signal. I believe the switch is broken or the switch does not receive a signal to switch. I have a problem receiving the Thaicom 2-5 Sat, Ku-band and C-band using a DiSEQc between two dishes. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |